Y’all might recall a post a few months back where-in I apparently accidentally challenged Thor to a duel and pretty much everything we own was seriously damaged in a series of severe storms…
Destroyed roof and severe window damage on Cupola Art.
Hail-totaled roof on The Old Vic
Hail-totaled roof, windows, garage door, light-fixtures on The Suburban Blah House.
Totaled Little Rivet (but it’s not insured so I’ll just drive it).
Totaled Big Iron (also not insured)
$10k in damages to Da’ Altima (8 weeks in the shop).
The roof damage on Cupola Art was serious (along with the windows) and despite the tarps, we took a lot of interior damage…something like 640 square feet of ceiling and insulation came down, several light fixtures were damaged, and we lost some furniture and art…and art supplies.
Materials shortages, labor shortages, and the chaos in the industry due to the sheer amount of damage in north Texas area slowed things up a bit…but finally…the good news is starting! We have a roof on The Cupola! Woot!
First…the stuff showed up.
Then, on the day work was to start…as we were sitting there, dude goes by several times with this on a truck. He looked lost so I flagged him down and said, “That’s for me!”
…and he just GAVE it to me. Ain’t life great!
Very shortly though, the roofers showed up and spoiled my fun. They used the machine to lift huge piles of money on top of my roof.
The “thing” now…due to cost and durability, is a pvc barrier over insulation, the insulation fairs the roof deck as well as…well…insulating…it is a structural foam product and is easily firm enough to walk on without damaging.
The foam is screwed down to the existing roof deck with a few thousand big-honkin screws (technical term).
This is a small one.
The barrier is a PVC product that is 60 mil thick, and reflective white.
It is 10′ wide and screwed down with the same large screws used on the insulation and a particular washer that gives some more bite to the product.
Step one: Install insulation and fair up roof. (they had various widths and wedges of foam to level things out).
Next the barrier/TPO went down. It is screwed all along the edge and then the seams are chemically and heat fused. This part went surprisingly fast.
Then the real work started…terminating all the walls and edges…the TPO is brought up and over the walls and screwed down with metal bars on top. It is heat-formed to the contours of the walls and glued to them. That work is what I call “fiddly bits” and is most often the hard part. This took 8 men the better part of two days to accomplish.
One problem this roof has always had was water could stand at the back…and this damages roofing materials. They faired the area with foam and made everything run to the scuppers.
The tower has endured decades of minor damage…I have work to do here. It is not leaking. This fall I will get up here and screw everything down, and add flashings to resemble the missing shingles (mostly not visible from the ground).
Somewhere in there I also constructed a new, two-piece roof hatch…much heavier than the last one which was demolished in the storm…and the roofers nicely covered that with TPO…
This is a better roof than has ever been installed on this building…so that is forward progress. R-20 insulation, COMPLETELY water-tight, extensive warranty, reflective white, and best of all…did I mention water-proof?
Next…we fix the inside. Ugh.